Abstract
Compressive contact stress between the patella and the anterior femur and between the quadriceps tendon and anterior femur was measured before and after total knee arthroplasty in 5 cadaver knee specimens using a digital electronic sensor. Contact stresses were measured in the normal knee and after total knee arthroplasty with an unresurfaced patella, a dome-shaped patella, and a conforming patella. Patellofemoral contact stresses did not change significantly after total knee arthroplasty when the patella was not resurfaced, but they increased significantly after the patella was resurfaced with both the dome-shaped and the conforming components. The conforming patella had the highest contact stresses because it tilted at flexion angles greater than 90° and applied load to a small area on the superior portion of the patellar component. The conforming patella markedly decreased tendofemoral contact force because the thicker superior pole of the patella tented the quadriceps tendon at flexion angles greater than 120°. This further increased patellofemoral contact force in deep knee flexion.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
