Abstract
Background Overtensioning of medial patellofemoral ligament reconstructions may lead to adverse surgical outcomes. Hypothesis Increasing tension on a medial patellofemoral ligament graft will increase patellofemoral contact forces and decrease lateral patellar translation. Study Design Controlled laboratory study. Methods Patellofemoral contact pressures were measured in 8 fresh-frozen cadaveric knees before and after transection of the medial patellofemoral ligament and after a standardized reconstruction surgery. Contact pressures were measured at 3 knee angles (30°, 60°, and 90°) and under 3 levels of tension applied to the graft (2, 10, and 40 N). For each condition, patellar translation was measured at 30° of knee flexion as a 22-N lateral force was applied. Results Graft tension of 2 N restored normal translation, but 10 N and 40 N significantly restricted motion (5.2 mm and 1.9 mm, respectively). Compared with the intact knee, medial patellofemoral contact pressures significantly increased (P < .05) when 40 N of tension was applied to the reconstruction. Medial contact pressures were restored to normal with 2 N of graft tension. Lateral patellar translation was significantly greater (P < .05) after the medial patellofemoral ligament was cut (16.3 mm) compared with intact (7.7 mm). Conclusion Low (2-N) tension applied to a medial patellofemoral ligament reconstruction stabilized the patella and did not increase medial patellofemoral contact pressures. Higher loads (10 N and 40 N) progressively restricted lateral patellar translation and inappropriately redistributed patellofemoral contact pressures. Clinical Relevance Overtensioning can be avoided by applying low loads to medial patellofemoral ligament reconstructions, which reestablished normal translation and patellofemoral contact pressures.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have