Patellofemoral Contact Pressure for Medial Patellofemoral Ligament Reconstruction Using Suture Tape Varies With the Knee Flexion Angle: A Biomechanical Evaluation

Abstract

The purpose of this study was to evaluate the effect of the knee flexion angle during graft fixation on patellofemoral (PF) contact pressure in medial patellofemoral ligament (MPFL) reconstruction using polyester suture tape and knotless anchors. Nine human knees (mean age 74.9 ± 14.1 years) were used in this study. Polyester suture tape was fixed at the medial edge of the patella with two 3.5-mm knotless anchors, and then to the femur with a 4.75-mm knotless anchor at 4 different knee flexion angles (0°, 30°, 60°, and 90°). A pressure sensor was used to measure the maximum contact pressure (MCP) of the medial and lateral PF joints in the intact knee and in postreconstruction knees at each knee flexion angle (0°, 30°, 60°, and 90°). Each MCP was normalized to that of the intact knee. A statistical comparison was made between MCP in the intact and reconstructed knees. The normalized MCP of the medial PF joint fixed at either 0° or 30° significantly increased at 60° of knee flexion (P= .036 and .042, respectively) and at 90° of knee flexion (P= .002 and .001, respectively). Conversely, the normalized MCP fixed at 60° and 90° remained at the same level as the intact knees at all angles of knee flexion. The normalized MCP of the lateral PF joint showed no significant difference at any fixation angle compared with intact knees. To avoid excessive PF joint contact pressure after MPFL reconstruction, it may be best to fix polyester suture tape between 60° and 90° of knee flexion. Fixation of the polyester suture tape with a knotless anchor for MPFL reconstruction should be at 60° to 90° of knee flexion to most closely restore PF joint contact pressures to that of the intact knee.