Passive mitigation of low-frequency vibration modes in lightweight structures based on a new generation of acoustic black holes

Abstract

Topology optimization and generative design are methods used to lighten structures under specific loads. The resulting lightweight components are usually softer in the directions perpendicular to the applied efforts, such as in the case of cranes. This results in the possible excitation of structural modes at very low frequencies, which can lead to premature aging of lightweight structures. In this paper, we present a new design of acoustic black hole (ABH), able to mitigate vibration modes in a test 3D-printed lightweight structure, from 20 Hz upwards. The novel ABH weights less than 10 grams and can be readily screwed on the structure. Its design is based on that of a classic ABH, with additional winglets and/or rods, to increase the vibrating mass without significantly changing the stiffness of the ABH. This results in a strongly reduced ABH cut-on frequency. The winglets and/or rods also result in a greatly increased contact area between the ABH and the viscoelastic dissipative material, with positive effects on the ABH damping efficiency. The new ABHs could successfully be used, first to damp the fundamental vibration mode of aluminum cylinders, and then to reduce the amplitude of the first three structural modes of the test lightweight structure. The new ABH manages to damp modes at frequencies several times lower than the ones found in the literature, which are promising results.