Particle mass flow determination in dust-laden supersonic flows by means of simultaneous application of optical measurement techniques

Abstract

Particle mass flow rate and particle mass concentration are key parameters for describing two-phase flows, especially for particle-induced heating augmentation analysis. This work addresses the question of how accurate particle mass flow rate can be determined with three non-intrusive measurement approaches, based on shadowgraphy, particle tracking velocimetry (PTV), and scattered light intensity, in supersonic flows. In terms of shadowgraphy and PTV, the particle mass flow rate was determined by measuring individual particle characteristics, namely particle size, velocity, and density, as well as the measurement volume. The presented shadowgraphy procedure is based on the commercial LaVision DaVis software and additional shadowgraphy corrections. Multiple tests were conducted in the experimental test facility GBK of DLR with varying flow conditions, at a Mach number of 2.1, unit Reynolds number (Re∞) ranging from 5e7 1/m to 1.5e8 1/m, total temperature (T0) ranging from 303 to 544 K, and particle materials, namely Al2O3, MgO, and SiO2, in the size range of 1 to 60 µm. Particle size distributions of Al2O3 and MgO particles could be reproduced with shadowgraphy quite well, while the PTV procedure resulted in non-similar distributions. Pycnometer measurements indicated MgO particle density to be significantly lower than reference values. A DaVis parameter variation analysis resulted in a particle mass flow rate uncertainty of shadowgraphy of up to 30%. The particle mass flow rate uncertainty of PTV is approx. 76%, and the respective uncertainty of scaled PTV and scattered light intensity approach is 28%. The particle mass flow rate, measured with shadowgraphy, is 58% higher than those of the semi-axisymmetric scattered light intensity approach, which can be explained by a higher particle concentration at the injection plane.