Particle Injection in Direct Current Air Plasma Spray: Salient Observations and Optimization Strategies

Abstract

External injection of high-melting point low thermal conductivity ceramics orthogonal to a typical direct current thermal plasma jet plays a vital role in determining the in-flight state of the particles and the process downstream. The interactions between low density ceramic particles and high temperature plasma jet is quite complex, which influences the spray process and associated deposition. Detailed in-flight particle diagnostics as well as spray stream visualization have significantly enhanced our capability to diagnose and control the process. In this paper we present some salient observations on the role of key variables on particle injection. A number of experiments were conducted using a 7MB torch (Sulzer Metco, Westbury, NY) with both Ar–H2 and N2–H2 plasma gases, where the carrier gas flow to inject Yttria Stabilized Zirconia (YSZ) was varied systematically and the resulting in-flight particle state was captured using an array of particle and spray stream sensors arranged in a 3D set-up. A notable observation is the existence of a “sweet-spot” in the plasma jet where the particle temperatures and velocities achieved a maximum. This sweet-spot can be characterized by the plume position (location of centroid of the spray stream) rather than carrier gas flow rate and is independent of primary gas flows and other process/material conditions. This result suggests a possible approach to optimize particle injection independent of plasma-forming-torch-parameters. Controlling particle injection at this sweet-spot has shown to benefit the overall process efficiency (in terms of melting) and process reliability (both in-flight measurement and coating build-up) with concomitant application benefits.