Partially Lacerated Digital Flexor Tendons: A Cadaveric Study Determining the Intact Cross-sectional Area and Biomechanical Analysis.

Abstract

The extent of injury in partially lacerated tendons has conventionally been expressed as a percentage of the total tendon, to justify surgical repair. We propose a more objective method to estimate the cross-sectional area of the remnant intact tendon and to determine if the remaining tendon fibers can withstand the tensile forces of early active mobilization against resistance. The study was done on 20 cadaveric specimens, which were randomly assigned to receive a laceration of 25%, 50%, or 75% of the measured transverse tendon diameter. The circumference of the remaining intact portion of the partially lacerated tendon was measured and converted using a formula to determine the derived cross-sectional area (D-CSA). These D-CSA values were then validated by comparing them to digitally measured cross-sectional areas using a computer software program (computer-measured cross-sectional area, C-CSA). In addition, the ultimate tensile strength (UTS) of these partially lacerated tendons was analyzed to determine if a threshold exists beyond which surgical repair of a partially lacerated tendon is indicated. We found that the D-CSAs matched moderately with C-CSAs, with 0.622 of Pearson correlation coefficient. The UTSs of tendons with CSAs above 8 mm in circumference were consistently above 150 N. Measurement of the circumference of the partially lacerated tendon to obtain the D-CSA could be an accurate and practical method to benchmark residual tendon strength in the management of partially lacerated tendons.