Abstract
Separation of anabolic and androgenic steroids by micellar electrokinetic chromatography (MEKC) has been little studied. Simultaneous separation of the endogenous α-epimers testosterone and epitestosterone has not been achieved with any electroseparation technique. Here, a partial filling micellar electrokinetic chromatographic (PF-MEKC) method is described for the analysis of three endogenous steroid hormones (androstenedione, testosterone, epitestosterone) and two synthetic anabolic steroids (fluoxymesterone, methyltestosterone). The resolution efficiency of single-isomer sulphated γ-cyclodextrins and the surfactants sodium dodecyl sulphate and sodium taurocholate was exploited. The method is based on the sequential introduction of short plugs of two different pseudostationary phases into the capillary. The separation was completed in less than 10 min. The method can be used in quantitative analysis. Linear correlation was obtained between concentration and peak area of 0.996 or better. The repeatability (RSD) of the compound peak areas ranged from 3.6% (methyltestosterone) to 6.2% (androstenedione). Limits of detection were between 73 μg/L (testosterone) and 160 μg/L (fluoxymesterone). As a demonstration of the method, androstenedione, testosterone and epitestosterone were determined in a spiked urine sample.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.