Abstract
The measurement of partial discharge (PD) is used in the performance assessment of an insulation system in high voltage components. Through modeling the discharge process a better understanding of the phenomena may be attained. This paper is an extension from previous works by the same authors which have considered the modeling of PD activity from a spherical cavity by using Finite Element Analysis (FEA) method. However, this paper describes the development of an improved model for a spherical cavity within a homogeneous dielectric material. The model developed has been used to study the influence of applied frequency on PD activity. The model has also been used to simulate the PD measurement results. Therefore, parameters in the model that are affecting PD frequency dependent behavior can be identified through comparison between experimental measurement and simulation results.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
