Partial coverage adhesive augmented sternal fixation and stabilization: A biomechanical analysis

Abstract

Adhesive-augmented sternal fixation (AASF) has been investigated as an alternative to the clinical standard of cerclage wires; however, previous studies have focused on a full adhesive layer across the sternal midline, which acts as a barrier to bone healing. This study used a human cadaveric model to investigate if partial coverage AASF used in combination with wired fixation could provide adequate stability. Median sternotomies were performed on fifteen human cadaveric sterna. Three groups (n = 5) with varying adhesive coverage (50 %, 62.5 %, 75 %) of the sternal midline and traditional wiring were investigated. Cyclic lateral distraction loading of 10 N to 100 N was applied at 50 N/s. Every 30 cycles, the maximum load was increased by 100 N to a maximum of 500 N. Displacement was measured using transducers spanning the transection line at the manubrium, body, and xiphoid. Mean maximum total displacement (MMTD) for all groups was significantly below 2 mm (p < 0.001) with 1.49 mm ± 0.82 mm, 0.97 mm ± 0. 55 mm, and 0.67 mm ± 0.65 mm in the 50 %, 62.5 %, and 75 % groups respectively. MMTD in the 50 % group was significantly greater than MMTD in the 62.5 % and 75 % groups. AASF improved stability as coverage of the sternal surface with adhesive increased. Partial coverage of the sternal midline with adhesive may provide similar rigidity to a full layer while enabling earlier sternal ossification at the transection line compared to wiring alone.