Abstract
This study investigates an upcycling solution to transform AISI 303 stainless steel chips into powder feedstock for Direct Energy Deposition (DED) printing. All the chips were transformed into particles, using a disc milling process, in a size range of 38 to 212 μm with irregular shapes. The work proceeded by parametrizing DED printings on a non-preheated AISI 1045 substrate. Then, a wall-like structure was printed and submitted to microstructure, tomography, microhardness, tensile test and fracture analyses. The printed alloy showed a hardness of 220 ± 14 HV0.1 with a reducing tendency from the heat-affected zone to the topmost region, attributed to the formation of oxides and heat accumulation. The bimetallic specimen tensile test showed failure in the substrate region, verifying a good bonding of the interface. Tomography analysis also validated this result.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
