Parametric study on a compound-drop spray flame

Abstract

The introduction of compound-drop spray in a combustion system is a new concept. These droplets bear two gasification stages to cause an integral positive or negative effect on a premixed flame to raise or lower the local temperature of the gasification region. In this paper, we adopt a compound drop which contains a water core encased by a layer of shell fuel. A one-dimensional homogeneous lean or rich premixed flame with the dilute compound-drop spray was investigated by using large activation energy asymptotic analysis. The compound-drop spray burning mode was defined and divided into completely pre-vaporised burning (CPB), shell pre-vaporised burning (SPB) and shell partially pre-vaporised (SPP) burning modes by way of the gasification zones of the shell fuel and the core water relative to the flame position. The influences of the initial droplet radius, the shell-fuel mass fraction and the liquid loading of the compound-drop spray on the lean and rich flames were analysed. By means of the normalisation parameter of flame propagation mass flux (), enhancement, suppression or extinction of the compound-drop spray flame can be represented clearly. Furthermore, from the observation of extinction, the necessary conditions of extinction of a lean spray flame by the internal heat transfer are that the spray is a negative effect and causes a sufficient heat loss rate at flame sheet downstream side. For a rich spray flame, three extinction patterns were observed; they occur in SPP, SPB or at the critical SPB mode, but do not in CPB. The extinction maps of the compound-drop spray demarcate the patterns and also indicate the limitations and corresponding conditions of the flame extinction.