P819 Outflow graft twist occlusion in the heartmate 3 left ventricular assist system in 7 cases: analysis of potential mechanisms using computed tomography

Abstract

Abstract Background Twist of the outflow graft (OG) of the HeartMate 3 left ventricular (LV) assist device (HM3) with subsequent occlusion is a rare, but life-threatening complication. Purpose We evaluated if potential implantation technique dependent mechanisms of OG twist can be predicted by multislice computed tomography (MSCT). Methods We retrospectively analyzed clinical, echocardiographic and MSCT data of 7 patients with angiographically proven and surgically corrected OG twist and of 11 consecutive patients without any type of pump obstruction. MSCT parameters were: position of inflow cannula related to anatomical LV apex (1), angulation of axis of inflow cannula related to LV axis (2), orientation of outflow channel of the pump housing related to LV axis (3), OG course (4). Echocardiographic parameters were LV end-diastolic diameter (LVEDD) and aortic valve opening. Results Mean time from implantation to twist was 563 ± 161 days. Preoperative LVEDD (64.6 ± 9.8 mm vs. 67.4 ± 10.2 mm, p = 0.563) was similar. LVEDD reduction after implantation (20% vs. 28%) and prevalence of aortic valve opening was higher in the twist group (71% vs. 45%). The MSCT measurements showed a high degree of heterogeneity in both groups: (1) differed from superior to infero-lateral; (2) varied from cranial to caudal, lateral and medial; (3) varied from antero-septal to inferior. (4) showed an incidence of non-obstructive kinking of 29% and 36%, respectively. Conclusion Marked heterogeneity of the measured MSCT parameters was observed in both groups. No specific pattern or geometric relation could be attributed to the OG twist phenomenon.