Abstract
Here, we studied the influence of pre- and post-thermal annealing on the performance of polymer:fullerene bulk heterojunction solar cells using the conventional architecture, comprising a conjugated polymer, namely, poly(3-hexylthiophene-2,5-diyl) (P3HT) and a fullerene derivative [6,6]-phenyl-C60-butyric acid methyl ester (PC60BM) as a photoactive layer. The non-annealed active layer device exhibited a power conversion efficiency of <1 % , which was significantly lower than the pre- and post-annealed devices. To investigate the impact of pre- and post thermal annealing on the natural morphological state of the polymer, regiorandom (P3HT-I) and regioregular (P3HT-II) type P3HT were compared in photoactive layers. In general, P3HT-I is amorphous, whereas P3HT-II is semi-crystalline. Changes in solar cell performance were associated with changes in carrier extraction efficiencies influenced by the annealing conditions. The charge photogeneration processes were investigated using spectroscopic techniques, including electroluminescence, steady-state, and time-resolved photoluminescence spectroscopy. Finally, to explore the morphological changes upon annealing, atomic force microscopy and electroluminescence imaging measurements were performed on films and solar cells, respectively.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
