Abstract
The back cover is mainly used to strengthen the display product strength, increase rigidity, and prevent product deformation and distortion during assembly, use or transportation. This thesis studies the influence of different back cover thickness, backplane material and stiffener position, number of stiffeners, and stiffener structure on the strength of the backplane. Good display support structures are required that not only can offer better sustentation results, but also can reduce the negative effect with lesser back cover materials. By simulating and optimizing the design of the backplane, the strength of the product is increased and the unit price of the product is reduced.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callSimilar Papers
More From: SID Symposium Digest of Technical Papers
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
