Oxidized cellulose as bio‐adhesive for hydrophobic lignocellulosic bioplastic

Abstract

AbstractThis study presents a novel hydrophobic lignocellulosic bioplastic from corn stover reinforced by oxidized cellulose and in situ regenerated lignin. Cellulose‐lignin mixture as a matrix was obtained by acid‐recyclable deep eutectic solvent (DES) pretreatment of corn stover in mild conditions. Triethoxy(octyl)silane (C14H32O3Si) was employed to improve the water stability of the bioplastic by vapor deposition. The results show that the hydrophobic bioplastic has a high tensile strength, measuring 62.36 MPa. The water contact angle of the bioplastic was increased from 8.50° to 121.9° after hydrophobic modification. We prepared oxidized cellulose‐reinforced cellulose paper by different particle size distributions of oxidized cellulose to investigate the reinforcement of oxidized cellulose. The tensile strength of oxidized cellulose cellulose paper increased from 14.41 to 21.18 MPa with the addition of oxidized cellulose. The zeta potential of oxidized cellulose is −47.99 mV, which shows a more negative charge due to carbonyl groups. The repulsive force of oxidized cellulose contributes to the formation of a brick‐and‐mortar microstructure with cellulose‐lignin mixture. It demonstrates that oxidized cellulose can act as bio‐adhesives and has a good toughening effect on the mechanical properties of bioplastic.Highlights Lignocellulosic bioplastic was prepared by DES pretreatment of corn stover. Oxidized cellulose was used to reinforce the lignocellulosic bioplastic. The tensile strength of the bioplastic was 62.36 MPa after the reinforcement process. Trieth‐oxy(octyl)silane was employed to improve water stability. The water contact angle of the bioplastic was increased from 8.50° to 121.9°.