Oxide-Free SiC-SiC Direct Wafer Bonding and Its Characterization

Abstract

There are different requirements for the production process and the final product of SiC-SiC wafer bonding. The manufacturing of devices that are sensitive to high temperature processing – due to broadened doping profiles and induced thermal stresses – requires room temperature bonding with high bond strength, while for electrical devices, it is mandatory that the bonding interface with a thin amorphous layer is oxide-free.[1] Reduced complexity of processes is also an important point for the final production. Hence, the goal of this work was to perform and characterize direct bonding of SiC-SiC without any added/deposited bonding layer. This type of bonded SiC wafers can be used for power electronics such as for the fabrication of traction inverter for automotive applications, DC/DC converter, on board charger or charging station.[2]For the wafer bonding processes standard 100 mm 4H SiC wafers were bonded with their Si-terminated faces in order to fabricate oxide-free bonds. The wafer bonding process was performed using the EVG ComBond® system: first the native oxides from both wafer surfaces were removed using an ion beam sputtering process, followed by the transfer of both wafers to the bonding process station operated in ultra-high vacuum (UHV) to significantly retard the oxidation process. Finally, the bonding process was performed at room temperature (RT).The goal of this study was to demonstrate the feasibility of the bonding process and to gain insight on the surface chemistry after activation. The investigations covered three areas: incoming inspection of the original wafer, characterization of activated single wafer and analysis of bonded wafer pairs. The focus was on compositional, chemical, mechanical and morphological analysis of the surfaces and of the bonded interfaces. In the case of single wafers, the focus of the incoming inspection was on whether the wafers fulfill the requirements of wafer bonding, and on the characterization of activated wafers to measure the surface modifications. Atomic force microscopy (AFM), white light interferometry (WLI) and spectroscopic ellipsometry (SE) were used to determine the surface roughness, the wafer topography and the surface layer structure, respectively. All three parameters are essential for successful RT SiC-SiC wafer bonding. The change of the surface chemistry was investigated by angle resolved x-ray photoelectron spectroscopy (AR-XPS). The quality of the bonded wafers and the bonding energy were verified using scanning acoustic microscopy (SAM) measurements (Fig. 1) as well as the Maszara blade test. Furthermore, cross-section transmission electron microscopy (X-TEM) showed a bonding interface with a thin amorphous layer and no noticeable additional oxygen containing layer (Fig. 2). In order to gain quantitative elemental distributions of oxygen and argon, energy dispersive x-ray spectroscopy (EDXS) was applied.The work reported is a demonstration of the capability of the different characterization methods regarding SiC-SiC wafer bonding. Future work will focus on the investigation of the bonded interface characteristics in the function of the bonding process parameters and the annealing conditions.[1] F. Mu, M. Fujino, T. Suga, Y. Takahashi, H. Nakazawa and K. Iguchi, "Wafer bonding of SiC-SiC and SiC-Si by modified surface activated bonding method" 2015 International Conference on Electronics Packaging and iMAPS All Asia Conference (ICEP-IAAC), Kyoto, Japan, 2015, pp. 542-545, doi: 10.1109/ICEP-IAAC.2015.7111073.[2] Tsunenobu Kimoto, "Material science and device physics in SiC technology for high-voltage power devices" Jpn. J. Appl. Phys. 54 040103 (2015), doi: 10.7567/JJAP.54.040103. Figure 1