Oxidative Desorption of Adsorbed Sulfur on Platinum Surfaces Modified with Cerium Species

Abstract

In polymer electrolyte membrane fuel cells, hydrogen oxidation and oxygen reduction reaction occur at platinum (Pt) catalyst surface. Pollutants in air and hydrogen fuel, especially, sulfur (S) species, often strongly adsorb on the Pt surface, resulting in reduced electrochemically active surface area, namely poisoning effect. Because such poisoning causes the significant deterioration of cell performance and durability, understanding and control of adsorption behavior of S species are very important. Thus, it is necessary to develop a new method or material for recovery from S poisoning in anode.In this study, a Pt(111) single crystal electrode was modified with a Ce species and its electrochemical property was compared with a bare Pt electrode. The modification with Ce species was accomplished by immersion in a Ce (NO3)3 + HClO4 aqueous solution with bubbling Ar + H2 gas through the solution for 1 h or applying the potential at -0.2 V in a Ce (NO3)3 + HClO4 aqueous solution. The modification of Pt(111) electrode with Ce species drastically changed the electrochemical responses; hydrogen adsorption/desorption waves become smaller and adsorption/desorption waves of hydroxy group disappeared because of the presence of adsorbed Ce species. Adsorbed species was identified as a Ce3+ ion by XANES spectrum.After the bare Pt(111) electrode was immersed in an aqueous solution containing sodium sulfide, three types of adsorbed S species, HS and S/Sn were detected by XPS. HS was reductively desorbed from Pt electrode surface at potential cycling between 0.0 and 0.2 V vs. RHE (-0.2 and 0.0 V vs. Ag/AgCl). S/Sn species remained during this potential cycling but oxidatively desorbed when the positive limit of potential cycling was 0.6 V vs. RHE (0.8 V vs. Ag/AgCl). The hydrogen adsorption/desorption current gradually increased as repeating potential cycling between 0.0 and 1.0 V vs. RHE (-0.2 V and 0.8 V vs. Ag/AgCl).After the Ce-modified Pt(111) electrode was immersed in an aqueous solution containing sodium sulfide, an anodic current assignable to the oxidative desorption of S species appeared at 0.3 V. The peak current decreased as repeating potential cycling between 0.0 and 0.7 V vs. RHE (-0.2 V and 0.5 V vs. Ag/AgCl). After this potential cycling, the peak area of S2p region of XPS spectra decreased as well as Ce 3d peak. The oxidative desorption of S and Sn on the Ce-modified Pt(111) electrode took place at 0.5 V vs RHE (0.3 V vs. Ag/AgCl) which is much more negative than that of bare Pt(111) electrode (1.0 V vs. RHE (0.8 V vs. Ag/AgCl)). Thus, modification of Pt(111) electrode with Ce species promoted the oxidative desorption of S species.