Abstract
Stopped-flow rapid-scan spectrophotometry was employed to study complicated oxidation processes of ubiquinol-cytochrome c reductase (QCR) that was purified from bovine heart mitochondria and maximally contained 0.36 mol of ubiquinone-10/mol of heme c1. When fully reduced QCR was allowed to react with dioxygen in the presence of cytochrome c plus cytochrome c oxidase, the oxidation of b-type hemes accompanied an initial lag, apparently low potential heme bL was oxidized first, followed by high potential heme bH. Antimycin A inhibited the oxidation of both b-type hemes. The oxidation of heme c1 was triphasic and became biphasic in the presence of antimycin A. On the other hand, starting from partially reduced QCR that was poised at a higher redox potential with succinate and succinate-cytochrome c reductase, the b-type hemes were oxidized immediately without a lag. When the ubiquinone content in QCR was as low as 0.1 mol/mol heme c1 the oxidation of the b-type hemes was almost suppressed. As the Q-deficient QCR was supplemented with ubiquinol-2, the rapid oxidation of b-type hemes was restored to some extent. These results indicate that a limited amount of ubiquinone-10 found in purified preparations of QCR is obligatory for electron transfer from the b-type hemes to iron-sulfur protein (ISP) and heme c1. The characteristic oxidation profiles of heme bL, heme bH, and heme c1 were simulated successfully based on a mechanistic Q cycle model. According to the simulations the two-electron oxidation of ubiquinol-10 via the ISP and heme c1 pathway, which is more favorable thermodynamically than the bifurcation of electron flow into both ISP and heme bL, does really occur as long as heme bL is in the reduced state and provides ubiquinone-10 at center i. Mechanistically this process takes time, thus explaining the initial lag in the oxidation of the b-type hemes. With the partially reduced QCR, inherent ubisemiquinone at center i immediately oxidizes reduced heme bH thus eliminating the lag. The mechanistic Q cycle model consists of 56 reaction species, which are interconnected by the reaction paths specified with microscopic rate constants. The simulations further indicate that the rate constants for electron transfer between the redox centers can be from 10(5) to 10(3) s-1 and are rarely rate-limiting. On the other hand, a shuttle of ubiquinone or ubiquinol between center o and center i and the oxidation of heme c1 can be rate-limiting. The interplay of the microscopic rate constants determines the actual reaction pathway that is shown schematically by the "reaction map." Most significantly, the simulations support the consecutive oxidation of ubiquinol in center o as long as both heme bL and heme bH are in the reduced state. Only when heme bL is oxidized and ISP is reduced can SQo donate an electron to heme bL. Thus, we propose that a kinetic control mechanism, or "a kinetic switch," is significant for the bifurcation of electron flow.
Highlights
The mechanistic Q cycle model consists of 56 reaction species, which are interconnected by the reaction paths
Reaction of Fully Reduced QCR with Dioxygen in the Presence of Cytochrome c Plus cytochrome c oxidase (CCO)—Fig. 1A shows three-dimensional display of spectral changes recorded on mixing dithionite-reduced QCR (0.36 mol of Q10/mol of heme c1) with an air-saturated solution containing cytochrome c and CCO in the stopped-flow rapid-scan apparatus
The concentration of cytochrome c was 6 –7-fold lower than that of CCO or of QCR to minimize its spectral contribution to the absorbance change of heme c1 around 553 nm and to control the rate of its oxidation
Summary
Succinate-cytochrome c reductase [27], ubiquinol-cytochrome c reductase [6], and cytochrome c oxidase [20] were purified from beef heart muscle according to previously reported methods and stored at 280 °C until used. Method 1: purified QCR was diluted with 50 mM sodium phosphate buffer (pH 7.4) containing 0.25% sodium cholate to give a final concentration of 6 –7 mM heme c1 and placed in one of the reservoirs of the stopped-flow apparatus. Method 2: a mixture containing QCR (6 –7 mM cytochrome c1), 1 mM cytochrome c, and CCO (6 –7 mM aa3) in 0.25% sodium cholate, 50 mM sodium phosphate buffer (pH 7.4) was placed in one reservoir and bubbled with a gas mixture of CO and N2 (1:4) for 10 min at 20 °C. An air-saturated solution containing 50 mM sodium phosphate buffer (pH 7.4), 0.25% sodium cholate, and no protein components was placed, and the temperature was equilibrated at 10 °C. Numerical calculations for solving the differential equations that represent a reaction model were performed by using MATLAB on a desktop computer (Dell, OptiPlex XMT 5133)
Sign-in/Register to view highlights & summary Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a call
