Abstract
Heterogeneous photocatalysis (HP) using UV/TiO 2, photo-Fenton (PF) reaction using UV/Fe/H 2O 2 and the combination UV/TiO 2/Fe/H 2O 2 (HP–PF) were tested as processes to degrade oxalic acid (Ox) at relatively high concentrations (0.032 M). PF reactions were generally more efficient than HP including the reaction in the absence of H 2O 2. Oppositely to previous results (e.g., with EDTA), HP–PF combinations did not result, in the case of oxalate, better techniques for degradation than systems in the absence of TiO 2. The kinetic behavior was not unique and two parameters were taken to evaluate the efficiency of each system: initial rates ( R 0) and time to 95% of total mineralization (TOC 95). Addition of hydrogen peroxide improves the initial HP reaction rate and reduces TOC 95. Addition of Fe 3+ also affects the reaction parameters but the effect of H 2O 2 seems to be higher, at least under the present conditions. When both H 2O 2 and iron were added simultaneously, the efficiency was higher. The optimal H 2O 2:Ox:Fe molar ratio was established and the results indicated that, at a fixed iron concentration, H 2O 2 increased R 0 until a limit beyond which it did not cause any effect. No intermediates were formed in the reaction, oxalate being degraded directly to CO 2. Analogies and differences with the EDTA system are presented.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.