Abstract

Considering the anisotropy of microstructure of additive manufactured metal materials, quantitative assessment of the anisotropy of fatigue crack growth (FCG) behavior is necessary for structural damage tolerance design and evaluation. This study conducted an experimental and mechanistic investigation of the FCG behavior of the laser metal deposited (LMD) Ti–6Al–4V alloy, focusing on the anisotropy of FCG and the effect of overload on FCG. Both the FCG experiments with constant amplitude loading (CAL) and with a single overload (OL) were performed in different directions. Under CAL, the FCG rate exhibits a bilinear correlation with the stress intensity factor. Before the transition point (ΔKT = 16.9 MPa√m), since the grain boundaries are sparser along the columnar crystal growth direction, the FCG rate in the XY specimen is higher than that in the other directions. When the FCG rate further increases, the hindrance effect of grain boundaries on FCG weakens, and the anisotropy of FCG rates disappears. An interesting new finding is that when an overload is applied after ΔKT, the FCG rates in the XZ and ZX directions become different, and the overload-induced anisotropy increases with the overload ratio (OLR). The difference in FCG rates between the two directions exceeds 23.2% when OLR is 2.5. Based on microscopic and theoretical analysis, it was demonstrated that the overload induces residual strain in front of the crack-tip and enhances FCG resistance. The FCG resistance is positively related to the size of the plastic zone and negatively related to the yield strength in the loading direction.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call