Osseointegration by bone morphogenetic protein-2 and transforming growth factor beta2 coated titanium implants in femora of New Zealand white rabbits

Abstract

Background:Intramembranous bone formation is essential in uncemented joint replacement to provide a mechanical anchorage of the implant. Since the discovery of bone morphogenic proteins (BMPs) by Urist in 1965, many studies have been conducted to show the influence of growth factors on implant ingrowth. In this study, the influence of bone morphogenetic protein-2 (rhBMP-2) and transforming growth factor β2 (TGF-β2) on implant osseointegration was investigated.Materials and Methods:Thirty-two titanium cylinders were implanted into the femoral condyles of both hind legs of New Zealand White Rabbits. Four experimental groups were investigated: controls without coating, a macromolecular copolymer + covalently bound BMP-2, adsorbed BMP-2, and absorbed BMP-2+TGF-β2. All samples were analyzed by ex vivo high-resolution micro-computed-tomography after 28 days of healing. Bone volume per total volume (BV/TV) was recorded around each implant. Afterward, all samples were biomechanically tested in a pull-out setup.Results:The highest BV/TV ratio was seen in the BMP-2 group, followed by the BMP-2+TGF-β2 group in high-resolution micro-computed-tomography. These groups were significantly different compared to the control group (P < 0.05). Copolymer+BMP-2 showed no significant difference in comparison to controls. In the pull-out setup, all groups showed higher fixation strength compared to the control group; these differences were not significant.Conclusions:No differences between BMP-2 alone and a combination of BMP-2+TGF-β2 could be seen in the present study. However, the results of this study confirm the results of other studies that a coating with growth factors is able to enhance bone implant ingrowth. This may be of importance in defect situations during revision surgery to support the implant ingrowth and implant anchorage.