Abstract
Based on the orthogonal experiment of grinding-hardening machine, this paper studied the influence of depth of cut ap, table speed vw and grinding method gm on the grinding-hardened layer’s depth and its uniformity of 45 steel. The results show that, depth of cut ap is the significant factor affected the average value of grinding-hardened layer’s depth, but the influence of grinding conditions on the uniformity are very limited. In actual application, it should adopt ap=0.6mm, vw=0.4m/min and up-down grinding method to enhance the quality of grinding-hardened layer.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
