Abstract
AbstractAt an extremely small extrusion rate, an isotactic polypropylene melt was extruded through a slit die of an extruder. Simultaneously, the extruded melt was stretched at various stretching rates (SRs) at the die exit. The oriented structure and its subsequent recrystallization via self‐seeding were investigated using polarized optical microscopy, two‐dimensional wide‐angle X‐ray scattering and small‐angle X‐ray scattering. As expected, much slenderer and denser oriented structures were formed at larger SR, which indicates that orientation is preferably promoted with increasing SR. In the case of the crystalline morphology developed during recrystallization, a shish kebab‐like structure was retrieved via the surviving oriented structure after annealing. Unexpectedly, for the sheet stretched at higher SR, a mainly sparse and short shish kebab structure was observed. For the sheet stretched at lower SR, a dense and long shish kebab structure was observed. This suggests that the oriented structure in the sheet stretched at lower SR has a better thermal stability than that in the sheet stretched at higher SR. This is discussed based on the relaxation of entangled junctions in the stretched networks with respect to varying chain length. Copyright © 2011 Society of Chemical Industry
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.