Oriented structure formation during polymer film extrusion

Abstract

AbstractAn experimental technique is described for producing fiberreinforced polymer films by inserting needle‐like obstructions in a film‐extrusion die. The, needles act as nucleation sites, generating a highly extensional local flow field, which causes sufficient orientation to induce the formation of oriented fibrillar crystallites embedded in a much less oriented matrix. To study the effectiveness of the above technique, linear low density polyethylene (LLDPE) and blends of linear low density with high density polyethylene (HDPE) were extruded through a film die with converging walls, with one or five needles inserted parallel to the extrusion direction, Microscopy observations, birefringence, and differential scanning calorimetry (DSC) measurements performed on the produced films showed in all cases that the presence of the needle induced the formation of a more oriented phase, which in most cases had a birefringence at least an order of magnitude higher than the film matrix. The best results were obtained in the case when blends of HDPE and LLDPE were extruded. The oriented structures obtained in this case consisted of HDPE and exhibited not only high birefringence but melting point elevation as well, indicating their fibrous nature.