Optimum roughage proportion in barley-based feedlot cattle diets: growth performance, feeding behavior, and carcass traits.

Abstract

High grain diets are fed to finishing beef cattle to maximize animal performance in a cost-effective manner. However, a small amount of roughage is incorporated in finishing diets to help prevent ruminal acidosis, although few studies have examined optimum roughage inclusion level in barley-based diets. The objective of the study was to evaluate the effects of roughage proportion in barley-based finishing diets on growth performance, feeding behavior, and carcass traits of feedlot cattle. Crossbred beef steers (n = 160; mean body weight ± SD, 349.7 ± 21.4 kg) were allocated to 20 pens that were assigned randomly to four dietary treatments (five pens of eight steers per treatment). The treatment diets contained barley silage at 0%, 4%, 8%, and 12% of dietary dry matter (DM). The remainder of the diets (DM basis) consisted of 80%, 76%, 72%, and 68% barley grain, respectively, 15% corn dried distiller's grains, 5% mineral and vitamin supplement, and 32 mg monensin/kg diet DM. The diets were fed as total mixed rations for ad libitum intake (minimum of 5% refusal) once per day. Cattle were weighed on 2 consecutive days at the start and end of the experiment and on 1 d every 3 wk throughout the experiment (124 d). Two pens for each treatment group were equipped with an electronic feeding system (GrowSafe Systems Ltd., Calgary, Alberta) to monitor feed intake and feeding behavior of individual cattle. The data for dry matter intake (DMI), average daily gain (ADG), gain:feed (G:F) ratio, and carcass traits were analyzed as a completely randomized design with fixed effect of barley silage proportion and pen replicate as experimental unit. Feeding behavior data were analyzed similarly, but with animal as experimental unit. Averaged over the study, DMI increased linearly (11.1, 11.3, 11.7, 11.8 kg/d; P = 0.001) as barley silage proportion increased from 0%, 4%, 8%, and 12% of DM, but ADG was not affected (carcass-adjusted,1.90, 1.85, 1.87, 1.89 kg/d; P ≥ 0.30). Consequently, G:F ratio decreased linearly (carcass-adjusted, 168.9, 163.8, 158.5, 160.6 g/kg DMI; P = 0.023). When averaged over the study, proportion of barley silage in the diet had no linear or quadratic effects (P > 0.10) on meal frequency, duration of meals, intermeal duration, or meal size, but eating rate decreased linearly with increasing silage proportion (P = 0.008). There was no diet effect on liver abscesses (P ≥ 0.92), and effects on carcass characteristics were minor or nonexistent. We conclude that increasing the proportion of barley silage in a feedlot finishing diet at the expense of barley grain to minimize the incidence of ruminal acidosis may decrease feed conversion efficiency.