Abstract

The optimum operating conditions providing minimum run-time and running costs have been studied theoretically for a thermal diffusion plant to be used for the enrichment of the radiocarbon isotope from finite sample size.The calculations are based on a simple approximate model of the enrichment process, regarding the isotope separation column as operating under quasi-stationary state conditions. The temporal variation of the isotope accumulation is given by a single exponential term. From comparison with the numerical solution of the separation tube equation, approximate models of this simple type appear hardly sufficient for analytical work but seem well suited for optimization calculations. For column operation not too close to the equilibrium state, the approximate run-times were found accurate within 0.2 d.The approximate model has been applied to a column of the concentric type, operated on gaseous methane. Cross-section configuration and temperatures were not varied (hot and cold wall radii: 2.0 and 2.6cm, respectively; hot and cold wall temperatures: 400°C and 14°C, respectively). The column transport coefficients used were derived from measurements. Run-time was minimized by optimizing both the operating pressure and the sample collection mode for different total sample size (range studied: 24 to 100 g), mass of enriched sample (1.8, 2.4, and 3.0 g), enrichment factor (12, 15, and 20) and column length (8 to 18 m). Optimum working pressures are between 1 and 2 atm. Usually, about 90 percent of the enriched sample mass is extracted favorably from the column itself, the length of the sampling section being about 2.5 to 5 m. Typical runtimes are between 3 days and 2 weeks, and isotope yield may reach 90 percent.Optimum operating conditions have also been calculated for other column configurations reported in literature and are compared with the experimental results.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.