Year-end Sale % OFF 
Abstract
Utility boilers are used in thermal power plants. If exhaust flue gas temperature of a boiler is sufficiently high, heat recovery devices may be installed to increase the boiler efficiency. Previous investigations have focused on increasing boiler efficiency by using heat transfer from flue gas to remove moisture from fuel in flue gas dryer. Another method that is equally effective in increasing boiler efficiency is installing additional air heater to increase air temperature before combustion. The main objective of this paper is to determine the optimum sizes of flue gas dryer and additional air heater that minimize the total cost of installing them in an existing boiler. Models of utility boiler and flue gas are developed for this purpose. It is found that the installation of flue gas dryer after additional air heater results in lower total installation cost than the installation of flue gas dryer before additional air heater or the installation of flue gas dryer in parallel with additional air heater. Furthermore, both flue gas dryer and additional air heater should be installed if the ratio of the unit cost of flue gas dryer to the unit cost of air heater is between the lower and upper limits.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
