Abstract
Increasing circuit density in multilevel back-end-of line (BEOL) interconnects is necessary to improve integrated circuit performance and area scaling. Ultra low-k (ULK) dielectrics are used to minimize capacitance for lower power consumption and better capacitance-resistance (RC) performance. However, these materials pose integration and reliability challenges, which have limited our ability to scale the dielectric constant lower.1 Minimizing porosity, maximizing carbon content, and altering how carbon is bonded in porous SiCOH films reduces plasma-induced damage (PID) to the ULK and improves TDDB reliability, but these improvement must be balanced by maintaining other film properties such as elastic modulus. This paper describes one technique to achieve this combination of high carbon content and low porosity to allow k scaling while meeting integration and reliability requirements.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
