Optimizing the signal to noise ratio in speech rooms using passive acoustics

Abstract

Adults with normal hearing require roughly a 0 dB signal-to-noise ratio for good speech intelligibility. However, significantly higher values may be needed to compensate for neurological immaturity, sensorineural and conductive hearing losses, language proficiency and excessive reverberation. ANSI 12.60 addresses ways to lower the noise interference due to background levels and reverberation time. However, it is also possible to increase the signal, by reflecting or diffusing early reflections. Speech intelligibility is delivered in the consonants, which occur in the 2- 6 kHz frequency range. Therefore, intelligibility can be enhanced by incorporating scattering surfaces, rather than solely surfaces that absorb sound in the 2 - 6 kHz region, on the front wall, lower side walls and central ceiling areas, to increase the speech signal by temporal fusion. The decay time can be controlled with broadband absorption on the perimeter of the ceiling and upper wall surfaces. Since ceiling diffusion is an important design ingredient and the ceiling plane is coveted by many trades, including lighting, HVAC, speakers, sprinklers, etc., we will describe a 24 VDC combined LED lighting and sound diffusor, with a 24 VDC emergency lighting central battery system, dynamic lighting capability and the ability to incorporate sonic actuators for announcements.