Optimizing the nickel boride layer thickness in a spectroelectrochemical ATR-FTIR thin-film flow cell applied in glycerol oxidation

Abstract

The influence of the drop-casted nickel boride catalyst loading on glassy carbon electrodes was investigated in a spectroelectrochemical ATR-FTIR thin-film flow cell applied in alkaline glycerol electrooxidation. The continuously operated radial flow cell consisted of a borehole electrode positioned 50 µm above an internal reflection element enabling operando FTIR spectroscopy. It is identified as a suitable tool for facile and reproducible screening of electrocatalysts under well-defined conditions, additionally providing access to the selectivities in complex reaction networks such as glycerol oxidation. The fast product identification by ATR-IR spectroscopy was validated by the more time-consuming quantitative HPLC analysis of the pumped electrolyte. High degrees of glycerol conversion were achieved under the applied laminar flow conditions using 0.1 M glycerol and 1 M KOH in water and a flow rate of 5 µL min−1. Conversion and selectivity were found to depend on the catalyst loading, which determined the catalyst layer thickness and roughness. The highest loading of 210 µg cm−2 resulted in 73% conversion and a higher formate selectivity of almost 80%, which is ascribed to longer residence times in rougher films favoring readsorption and C–C bond scission. The lowest loading of 13 µg cm−2 was sufficient to reach 63% conversion, a lower formate selectivity of 60%, and, correspondingly, higher selectivities of C2 species such as glycolate amounting to 8%. Thus, only low catalyst loadings resulting in very thin films in the few μm thickness range are suitable for reliable catalyst screening.