Abstract
This study was performed on an alloyed FPVC sheet which was extruded under controlled conditions. Some of the conditions consisted of draw ratio, die temperature, melt temperature before die, center chill roll temperature and bottom roll temperature on a three roll down-stack sheetline
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
