Optimizing plant density and nitrogen application to manipulate tiller growth and increase grain yield and nitrogen-use efficiency in winter wheat.

Dongqing Yang,Tie Cai,Yongli Luo,Zhenlin Wang

doi:10.7717/peerj.6484

Dongqing Yang, Tie Cai + Show 2 more

Open Access

https://doi.org/10.7717/peerj.6484

Copy DOI

Abstract

The growth of wheat tillers and plant nitrogen-use efficiency (NUE) will gradually deteriorate in response to high plant density and over-application of N. Therefore, in this study, a 2-year field study was conducted with three levels of plant densities (75 ×104plants ha−1, D1; 300 ×104plants ha−1, D2; 525 ×104plants ha−1, D3) and three levels of N application rates (120 kg N ha−1, N1; 240 kg N ha−1, N2; 360 kg N ha−1, N3) to determine how to optimize plant density and N application to regulate tiller growth and to assess the contribution of such measures to enhancing grain yield (GY) and NUE. The results indicated that an increase in plant density significantly increased the number of superior tillers and the number of spikes per m2(SN), resulting in a higher GY and higher partial factor productivity of applied N (PFPN). However, there was no significant difference in GY and PFPN between plant densities D2 and D3. Increasing the N application rate significantly increased the vascular bundle number (NVB) and area (AVB), however, excess N application (N3) did not significantly improve these parameters. N application significantly increased GY, whereas there was a significant decrease in PFPN in response to an increase in N application rate. The two years results suggested that increasing the plant density (from 75 ×104plants ha−1to 336 ×104plants ha−1) in conjunction with the application of 290 kg N ha−1N will maximize GY, and also increase PFPN(39.7 kg kg−1), compared with the application of 360 kg N ha−1N. Therefore, an appropriate combination of increased planting density with reduced N application could regulate tiller number and favor the superior tiller group, to produce wheat populations with enhanced yield and NUE.

Highlights

Wheat is one of the most important food crops worldwide
Gain yield (GY), spike number per m2 (SN), 100-grain weight (TGW), the effective tiller rate (ETR), partial factor productivity of applied N (PFP), yield per spike, grain number per spike, the maximum grain-filling rate (Gmax); the mean grain-filling rate (Gmean), the active grain-filling period (T), and the associated vascular bundle parameters showed no significant effects of year (Yr), the interaction between Yr, plant density (D) and nitrogen application rate (N)
No significant differences in grain yield (GY) were observed between the N2 and N3 treatments across densities D1 and D2

Summary

Introduction

Wheat is one of the most important food crops worldwide. In China, where wheat has accounted for more than 20% of the total sowing area in recent years, production has substantially increased during the past few decades (Chen et al, 2017). Owing to continual population growth, the demand for wheat will continue to increase. Optimizing plant density and nitrogen application to manipulate tiller growth and increase grain yield and nitrogen-use efficiency in winter wheat. It is essential to ensure food security through increasing yield per unit area, to enhance the total production on a diminishing area on cultivated farmland

Objectives

Methods

Results

Discussion

Conclusion