Optimizing gas chromatographic–mass spectrometric analysis of selected pharmaceuticals and endocrine-disrupting substances in water using factorial experimental design

Abstract

An analytical method based on gas chromatography–mass spectrometry (GC–MS) has been developed to simultaneously determine selected acidic and neutral pharmaceuticals and endocrine-disrupting substances in surface and tap water. Solid-phase extraction (SPE) with Oasis HLB cartridges is followed by derivatization of the target analytes in the eluted extract. Derivatization was systematically optimized by employing a factorial experimental design. More specifically a central composite design was applied to search for the optimal conditions of the derivatization process and it was demonstrated that N-methyl- N-tert-butyl-dimethysilyl-trifluoroacetamide (MTBSTFA) had a better overall performance compared to N, O-bis(trimethylsilyl) trifluoroacetamide (BSTFA). The influence of solvent ratios and elution volumes while using SPE were also studied using a factorial design. The method was developed successfully for most of the selected compounds [i.e. ibuprofen, salicylic acid, gemfibrozil, naproxen, triclosan, propranolol, diclofenac, carbamazepine, 4-octylphenol (OP), 4-nonylphenol (NP), nonylphenol-monoethoxylate (NP1EO), nonylphenoxyacetic acid (NP1EC), estrone (E1), and 17α-ethinyloestradiol (EE2)]. Relative recoveries for spiked river and tap water ranged from 47 to 130% and 60–109%, respectively. Typical limits of detection were less than 5 ng/L in tap water and less than 10 ng/L in river water. Twelve target compounds were detected in river and tap water samples using the developed method. This method is currently used in bench-scale drinking water treatment studies.