Optimizing Formic Acid-Assisted Co-HTL of Digested Sewage Sludge and Lignocellulosic Waste for Enhanced Bio-Crude Yield and Energy Recovery

Abstract

In recent years, hydrothermal liquefaction (HTL) has gained attention as a means of enhancing and increasing the production of biofuels from biomass. Co-HTL involves the simultaneous processing of two or more feedstocks, with the potential for interactions that can affect the overall yield and quality of the resulting biofuels. This study investigates the bio-crude yield, chemical composition, and energy content of bio-crudes obtained through formic acid-assisted hydrothermal liquefaction of combined digested sewage sludge (DSS) and lignocellulose (LC). The bio-crude yields are in the range of 26.8–58.9 wt%, with a higher heating value (HHV) of approximately 32 MJ/kg. The best experiment shows that mixtures with more DSS and high levels of process condition variables (350 °C, formic acid present, and 50 wt% EtOH) give high bio-crude yields with a maximum value of 58.9 wt%. For comparison, pure DSS and LC run at these process conditions resulted in a bio-crude yield of 52.5 wt% and 48.3 wt%, respectively. Partial least squares (PLS) regression reveals a synergistic effect from mixing the feedstocks, as the quadratic term of the regression equation for mixture ratio shows a negative coefficient. GC–MS data show that combining feedstocks results in the formation of new compounds, mostly phenols, that are not present in the bio-crudes from the separate feedstocks. Thus, combining feedstocks will not only increase the resource availability for hydrothermal liquefaction and streamline the process but will also increase the overall production of bio-crude with its synergistic effect.