Abstract

The optimized design and fabrication of a passive pressure and temperature sensor unit based on SAW transponder technology fully meeting the restrictions of the European ISM RF band at 433.92 MHz is presented. The sensor unit consists of a reflective SAW delay line which is used as temperature sensor and transponder, and a capacitive pressure sensor. With a special arrangement of the impedance loaded splitfinger interdigital transducer, and the reference reflectors on the SAW substrate, a temperature corrected evaluation of the pressure signal is enabled. Due to the small dimensions and cost-effective design of the sensor unit, the utilization as a tire pressure sensor is proposed. A prototype of the SAW delay line and the micromachined pressure sensor is demonstrated.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.