Optimization of Stack Emission Parameters Using Gaussian Plume Model

Abstract

Numerical simulation is an economical way to control air pollution because of its consistency and ease of use compared to traditional data sampling method. The objective of this research is to develop a practical numerical algorithm to predict the dispersion of pollutant particles around a specific source of emission. The algorithm is tested with a rubber wood manufacturing plant. Gaussian-plume model were used as air dispersion model due to its simplicity and generic application. Results of this study show the concentrations of the pollutant particles on ground level reached approximately 90μg/m3, compared with other software. This value surpasses the limit of 50μg/m3 stipulated by the National Ambient Air Quality Standard (NAAQS) and Recommended Malaysian Guidelines (RMG) set by Environment Department of Malaysia. The manufacturing plant is advised to make a few changes with its emission parameters and adequate values are suggested. In general, the developed algorithm is proven to be able to predict particles distribution around emitted source with acceptable accuracy.