Optimization of solder paste quantity considering the properties of solder joints

Abstract

PurposeThe purpose of this paper is to find an optimum between the quantity of solder paste and the desired properties of the soldered joint. A reduction of solder paste quantity is recognized as an opportunity to save money. On the other hand, the quantity of solder paste significantly influences the final properties of the soldered joint. The purpose is also to design recommendations for manufacturers of electronic assemblies.Design/methodology/approachThe processing of the paper was initiated by a literature review. The expert analysis was the next step. The result of analysis was a fishbone diagram. Subsequently, the experiment was designed. Seven types and three volume of solder pastes and two aperture shapes of the stencil were used. The measured parameters were mechanical strength, electrical resistance, voids area and intermetallic compound (IMC) thicknesses. The results of the experiment were evaluated and recommendations for practice were defined.FindingsThe carried out research has confirmed the influence of solder paste quantity on the shear strength, electrical resistance, voids area and IMC thickness of solder joint. The article presents the results achieved for solders Sn42Bi58, Sn42Bi57.6Ag0.4, SnAg3.0Cu0.5, SnCu0.7Ag1.0NiGe, SnAg3.5Bi0.5In8.0 and Sn62.5Pb36.5Ag1.0. Reduction of solder paste quantity down to 74 per cent (i.e. one quarter of quantity) decreases mechanical shear strength less than 10 per cent. Recommendations relating to the optimal reduction of solder paste quantity have been designed for each solder paste.Originality/valueContribution of the paper is impact assessment of solder paste quantity on the properties of the soldered joint. It was carried out a large number of experiments and measurements which verify this effect. Such a comprehensive overview of the results is not yet available in the literature. Recommendations for manufacturers of electronic assemblies are also the benefit of article.