Abstract
Optimization of grinding cycles means to consider and to control at least two characteristic quantities related to each other. Characteristics quantities might be for instance surface roughness and metal removal rate. Short grinding cycles last for instance 5… 30 s and result, if the grinding allowance is small. Usually you don't dress within such a cycle. The report essentially describes cycles occuring multistage with rough and finish grinding and being controlled uniaxially for instance by the infeed rate as a variable. Most important are for orthogonal grinding processes, strategies, relevant constraints and fundamental knowledge about the processes and their temporal changes as well as the interrelation between important characteristic quantities are premises for optimization.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
