Abstract
The shear test for flip chip solder bump was investigated in terms of effects of test parameters, i.e., shear height and shear speed, with an experimental and non-linear 3-dimensional finite element analysis for evaluating the solder joint integrity of area array packages. A representative Pb-free, Sn–3.0Ag–0.5Cu, was examined in this study. It could be observed that increasing shear height, at fixed shear speed, has the effect of decreasing shear force, while the shear force increased with increasing shear speed at fixed shear height. Relatively high shear height exceeding about 20% of the solder bump height could cause some unfavorable effects on the test results such as unexpected high standard deviation values or shear tip sliding from the solder bump surface. The low shear height conditions were favorable for screening the type of premature brittle interfacial fractures or the degraded layers in the interfaces. The increase in shear force with the shear speed is highly related with the stress values of the von Mises stress contours within the solder bump.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
