Abstract

AbstractElectric discharge machining wire-cut is an accurate and cost-effective manufacturing route in numerous applications. Taguchi method was used for the analysis of the effect of EDM wire-cut process parameters on material removal rate, surface roughness and machining time of magnesium alloys. Different parameters like pulse off time, pulse on time, current and voltage are used to optimize the material removal rate, surface roughness and machining time by Minitab 19. Taguchi orthogonal array L9 is used for optimizing three different parameters so that maximum material removal rate and minimum surface roughness and machining time is obtained.KeywordsEDM wire-cutTaguchi methodProcess parametersOptimizationMagnesium alloy

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.