Abstract
In this study, silica aerogel particles were synthesized from emulsion droplets as micro-reactors at room temperature under ambient pressure. An economical precursor, sodium silicate, was used as the starting material for silica, and an emulsification technique was applied to form droplets in continuous phase. By controlling the composition of the dispersed phase using ammonium hydroxide, the effect of pH on the morphologies of the final aerogel particles was studied by SEM observation. As a demonstrative application, hydrophobic silica aerogel particles were produced by modification using a silane coupling agent, for oil adsorption. The amount of oil adsorbed by the aerogel particles was optimized by adjusting the concentration of precursors in the emulsion droplets, the composition of the dispersed phase, and the concentration of the coupling agent during surface treatment of the particles. The resulting aerogel particles were characterized using BET, TGA, and the contact angle of water droplets after modification using silane coupling agents with different carbon numbers. The optimized value of adsorbed silicone oil (100 CS) was measured to be about 250 % relative to the weight of the aerogel particles. For comparison, other types of porous silica particles were also prepared from emulsion-assisted self-assembly routes to quantify the amount of adsorbed oil.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.