Abstract
AbstractThis paper describes optimization details of an analytical method development of a hydride‐generation procedure for speciation of mercury(II), monomethylmercury cation, dimethylmercury, and diethylmercury using a heated quartz furnace with an atomic absorption spectrophotometer (AAS) as a detector. Typically a new analytical method is developed in steps such as the following: (1) determining analytes individually to confirm retention times and the lack of decomposition during the procedure; (2) comparing peak areas of all analytes as a function of quartz furnace temperature to optimize atomization for AAS detection; (3) conducting factorial experiments to determine which hydride‐generation reaction conditions are important in maximizing peak areas and which conditions interact with each other; (4) using the simplex optimization method to give final optimization of reaction conditions. These steps result in conditions that maximize optimized peak areas for analytes while minimizing experimental error.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.