Abstract
Optimization of the parameter to provide best solution to reduce the tool wear , surface roughness, cutting forces presented using optimization technique .In present work an experimental study is made. In this Taguchi design of experiment methodology for optimization of parameters on 7075Aluminium alloy using tungsten coated electrode . Experiments were conducted based on L27 standard orthogonal array with three processes parameters are cutting speed, feed, depth of cut . Electrical discharge machining is generally calculated on the basis of Surface Roughness (SR),Tool wear rate (TWR) and cutting force (CF) .The ANOVA(Analysis Of Variance) is used to study the performance characteristics in turning operation . ANOVA placed an important role for producing higher roughness . Finally the software ,MINITAB 17 was used and results obtained .
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: International Journal of Recent Technology and Engineering (IJRTE)
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
