Abstract
The present study establishes the optimum process condition for additive mixed electrical discharge machining of Al7075–5%B4Cp metal matrix composite by performing experimental investigation. The suspension of chromium particles in a dielectric fluid is used as an additive. The input process parameters selected for experimentation are specifically pulse on-time, gap voltage, pulse off-time and peak current, for analysing their influence on wear of the tool along with surface roughness of the composite. Comparative study of the machined surface is done by analysing microstructures, cracks and recast layers formed at different settings of input parameters using a scanning electron microscope. Rise in amount of current and pulse on-time led to increased height of the recast layer generated on the surface of the machined workpiece. Furthermore, a confirmatory experiment was performed at the optimal setting. The result revealed an error of 5.5% and 7.5% between experimental and predicted value of tool wear rate and surface roughness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
