Abstract
The development of low-cost data acquisition equipment is relevant in the increasingly automated industry of today. This study presents the optimization of low-cost data acquisition equipment performance to achieve acquisition speeds of 200 kHz. This was possible by evaluating two essential aspects: considering the influence of the power supplied by the power source and changing the type of data used from “Double” to “uint”. This equipment was validated through the acquisition of known waves and vibration signals from a bearing test bench. The frequency component was satisfactorily identified in each case, for both the known waves and the damaged bearing components. This demonstrated the viability of developing low-cost data acquisition equipment that can be implemented to monitor bearing condition.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.