Abstract
Abstract This paper established a three-dimensional numerical model of segmented thermoelectric generator (TEG) for engines waste heat recovery. The thermoelectric materials are low-temperature Bi2Te3 and medium-temperature skutterudite. Two modes of segmented ratios of p-leg and n-leg are analyzed based on different boundary conditions, such as heat source temperature, cold source temperature and ratios of two thermoelectric materials. Suggestions on improving the output power and conversion efficiency are given based on the analysis. Results show that the performance of a segmented TEG with higher ratios of skutterudite is significantly better than that of a traditional TEG under larger temperature gradient. Enhancing the heat transfer from the heat source is a more effective method of improving the output power. Considering different thermal conductivity, the optimal Bi2Te3 ratio of p-leg is a little higher than that of n-leg. In addition, the design of segmented TEG should consider the temperature range of the heat and cold source to improve the output power and conversion efficiency to the utmost extent.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.