Abstract
This paper sheds light on the application of quality control tools to reduce Cycle time (including Weld time and Squeeze time). Successive use of these tools identifies and addresses the weakness and leads to improved processes. These tools address the problems in logical and sequential manners which are easy to observe and interpret the result. The main gist of this paper is to achieve the target cycle time of body build line. Cycle time includes process time, during which a unit is acted upon to bring it closer to an output. Every production line always has a target cycle time. With the collected data it was found that cycle time was higher than the target cycle time, so it needed to be optimized. There are lots of factors which are to be eliminated in order to achieve the target cycle time. The root cause of the factors affecting the target cycle time was observed using quality improvement tools known as the Ishikawa diagram or the ‘Fish Bone Diagram’. Article DOI: https://dx.doi.org/10.20319/mijst.2016.s21.98112 This work is licensed under the Creative Commons Attribution-Non-commercial 4.0 International License. To view a copy of this license, visit http://creativecommons.org/licenses/by-nc/4.0/ or send a letter to Creative Commons, PO Box 1866, Mountain View, CA 94042, USA.
Published Version (
Free)
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: MATTER: International Journal of Science and Technology
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
