Abstract
This study employed the Taguchi approach in combination with finite element analysis (DEFORM3D) to investigate face milling process onto AL6061. The factors studied in this investigation were cutting speed, feed rate, and axial rake angle. The simulation of flank wear was generated according to Usuis wear model though the L9 (34) of the orthogonal array experiment. ANOVA analysis and F test were conducted to find the significant factor that contributes to tool wear in the signal to noise ratio. Finally, the confirmation test has been carried out at optimal parameter.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
