Optimization in strength-ductility of Mg-Gd-Y-Zn-Zr alloy processed by upsetting-extrusion combined with intermediate thermo-mechanical treatment (ITMT)

Abstract

In this work, the effects of intermediate annealing and intermediate annealing subsequent aging treatment on the second phase precipitation, dynamic recrystallization (DRX) behavior, and mechanical properties of Mg-9Gd-4Y–2Zn-0.5Zr (wt.%) alloy were comparatively studied. The results showed that the one-pass upsetting-extrusion (UE) deformation intermediate annealing treatment sample (UAE) exhibited the highest dynamic recrystallized (DRXed) grains number fraction and the largest average DRXed grain size, which was mainly attributed to the precipitation of a large number of β-Mg5RE phases (>1 μm) at the grain boundaries (GBs) and within unDRXed grains after annealing treatment. These β-Mg5RE phases promoted DRX through particle-stimulated nucleation (PSN) mechanism during subsequent extrusion process. However, the lack of the pinning effect of the fine second phase precipitations led to the growth of DRXed grains. The DRXed grains of the deformation intermediate annealing subsequent peak-aging treatment sample (UAAE) were significantly smaller than the UAE sample. This is mainly due to the fact that the densely distributed prismatic β′ phases precipitated by the peak-aging treatment were rapidly transformed into nano-scale β-Mg5RE phases and pinned at the DRXed grain boundaries to inhibit the growth of the DRXed grains during the subsequent extrusion process. The ultimate tensile strength (UTS) and failure elongation (EL) of the UAAE sample were 274 MPa and 14.3%, respectively, 4.2% and 85.7% higher than those of the UE sample, showing excellent strength-ductility synergy. The randomly oriented fine DRXed grains, coarse unDRXed grains with high-density dislocations and substructures, and nano-scale β-Mg5RE particles were co-contribute to the strength-ductility synergy.